By Pieter Schillebeeckx, Product Director, TSL Products  

Audio Over IP has been in existence for quite some time, so it's difficult to call it a new or emerging technology. Axia Audio's

[caption id="attachment_69657" align="alignright" width="300"]Pieter Schillebeeckx, Product Director, TSL Products Pieter Schillebeeckx, Product Director, TSL Products[/caption]

LiveWire system was launched in 2003, for example. For that, you have to take your hat off to them; they designed and implemented their own Precision Time Protocol (PTP) before most people had heard of such a thing.

For some reason though it's taken this long for IP to catch the imagination of many broadcasters, and now the debate is heating up.

Ambitions for Audio Over IP (AoIP) in the broadcast community are set high. Some see it as a technology of ultra-convenience, or as a magic bullet for the bloated capital budgets that come with infrastructure and capacity upgrade - a high channel count transport system that can use existing IT provision. In practice, however, these might be false headlines – distractions from an even brighter future where infrastructure flexibility with software-driven routing of audio, video and metadata, complete with all-encompassing synchronization, is actually the main prize.

Studio Suite — Studio Hero

Take a typical US broadcast truck set-up. MADI is still king here, not just for linking trucks and stageboxes, but for providing feeds at every production position via audio monitoring units where personnel can create their own mix.

pg14-TallyMan-Virtual-PanelTo provide this they typically use a large video router expanded with MADI routing capability, sending out one MADI stream for eight positions, another one for the next eight, and so on. It's a little inefficient - you could pick off feeds from a single MADI loop, for example, but the central control is an important factor.

If you replace that with an AoIP network - AES 67, for example - you no longer need the 20U router; you can use a virtual patch panel on a simple App and the workflow stays the same. Reliability improves too - using multiple switches and distributor logic means that if one switch goes down, you might lose what's connected to that switch, but everything else will continue to work. If that central router goes down, you lose everything.

If you scale these gains up from a truck to a regional or national broadcast centre, then this kind of flexibility, control, and reliability, surely becomes the main incentive for making the move?

LiveU Pay-As-You-Go

To get there though, we must be realistic about the hurdles to practical implementation of AoIP and VoIP in the broadcast environment.

First, it is most likely that a broadcaster's IP transport will require a separate, managed network, which itself has a cost.dsf-b-thumb Dispensing with the central router is a goal worth striving for, but we shouldn't dismiss the network as a simple trip to the local computer store for some Cat5 and a few off-the-shelf switches. A network built and managed to tight parameters, with high enough bandwidth for audio and video, and capable of clean switching is certainly not trivial. Every point where you might have a camera really needs to have a 10Gb switch. A busy area on a network might be the video mixer on a live production, which would certainly require a 40Gb or even a 100Gb switch. This is neither commonplace nor inexpensive technology.

Audio-only is a different matter and its bandwidth requirements are tiny in comparison. A high-spec, nicely managed existing IT infrastructure with well managed Quality Of Service, VLAN, priority rules, and so on can cope with high numbers of audio channels with good reliability via 1Gb switching.

AoIP and VoIP are correctly termed layer 3 technologies, but maybe the requirement for specific network hardware and management challenges this in spirit and brings it into the realm of a layer 2 protocol like AVB?

AJA ColorBox

This leads to the second hurdle; all of this comes with the training and knowledge requirement that up until now has not been prevalent in the broadcast department. Staff will have to become fluent in IT, and comfortable with IT infrastructure. Some are already there, but many are not.

PAM2-MK2-with-screen-front-TSLShape_ThumbsToday's reality is that most implementations of Audio Over IP are straight replacements for an existing technology such as MADI or SDI. Yes, there are advantages such as using metadata for remote control of mic pres, for example, but the broadcaster's content-over-IP ideal - where audio and video share the same, synchronised, software-managed transport - while certainly on the horizon, is still in its infancy.

Technologies such as SMPTE ST 2059 - a SMPTE profile for the IEEE 1588 PTP, for example, could give the various AoIP and VoIP protocols a common sync-base that will be a significant enabler for synchronised IP content.

Audio and video over IP for broadcast is not really about cost. We don't think implementation of IP-based infrastructure will be significantly cheaper. However, a convincing argument can be made on significant and very practical gains.

Zixi

At TSL, we’re ready. We are already bringing our detailed knowledge and practical experience of AoIP to bear in existing installations. We are embracing the future and working on next generation audio and video monitoring products to support all flavours of audio and video over IP.

This approach, I believe, is the only way that manufacturers, integrators, and broadcasters alike will realise their IP ambitions.